Allied Telesis AlliedWare Plus User Manual

C613-50100-01 REV C Command Reference for x930 Series 1440
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ROUTE MAP COMMANDS
MATCH
IP ADDRESS
match ip address
Overview Use this command to add an IP address prefix match clause to a route map entry.
You can specify the prefix or prefixes to match by specifying the name of the prefix
list. To create the prefix list, enter Global Configuration mode and use the ip
prefix-list command.
A route matches the route map entry if the route’s prefix matches the access list or
prefix list.
Each entry of a route map can have at most one one prefix list-based IP address
match clause. If the route map entry already has one match clause, entering this
command replaces that match clause with the new clause.
Note that prefix lists and route map entries all specify an action of deny or permit.
The action in the prefix list determines whether the route map checks update
messages and routes for a given prefix. The route map action and its set clauses
determine what the route map does with routes that contain that prefix.
Use this command to add an IP address prefix match clause to a route map entry.
You can specify the prefix or prefixes to match by either:
• specifying the name of an access list. To create the access list, enter Global
Configuration mode and use the access-list command.
• specifying the name of a prefix list. To create the prefix list, enter Global
Configuration mode and use the ip prefix-list command.
A route matches the route map entry if the route’s prefix matches the access list or
prefix list.
Each entry of a route map can have at most one access list-based IP address match
clause and one prefix list-based IP address match clause. If the route map entry
already has one of these match clauses, entering this command replaces that
match clause with the new clause.
Note that access lists, prefix lists and route map entries all specify an action of deny
or permit. The action in the access list or prefix list determines whether the route
map checks update messages and routes for a given prefix. The route map action
and its set clauses determine what the route map does with routes that contain
that prefix.
Use the no variant of this command to remove the IP address match clause from a
route map entry. To remove a prefix list-based match clause you must also specify
the prefix-list parameter.
Syntax
match ip address {<accesslistID>|prefix-list <prefix-listname>}
no match ip address [<accesslistID>]
no match ip address prefix-list <prefix-listname>

Allied Telesis AlliedWare Plus Specifications

General

Brand	Allied Telesis
Model	AlliedWare Plus
Category	Switch
Language	English