Allied Telesis AlliedWare Plus - Chapter 14: Switching Commands; Introduction; Switching Commands

14
C613-50100-01 REV C Command Reference for x930 Series 443
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Switching
Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
switching.
For more information, see the Switching Feature Overview and Configuration
Guide.
Command List •“backpressure” on page 445
•“clear loop-protection counters” on page 447
•“clear mac address-table dynamic” on page 448
•“clear mac address-table static” on page 450
•“clear port counter” on page 451
•“clear port-security intrusion” on page 452
•“debug loopprot” on page 455
•“debug platform packet” on page 456
•“duplex” on page 458
•“flowcontrol (switch port)” on page 459
•“linkflap action” on page 461
•“loop-protection loop-detect” on page 462
•“loop-protection action” on page 463
•“loop-protection action-delay-time” on page 464
•“loop-protection timeout” on page 465
•“mac address-table acquire” on page 466
•“mac address-table ageing-time” on page 467
•“mac address-table logging” on page 468