C613-50100-01 REV C Command Reference for x930 Series 658
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LINK AGGREGATION COMMANDS
STATIC
-CHANNEL-GROUP
static-channel-group
Overview Use this command to create a static channel group, or add a member port to an
existing static channel group. Static channel groups are also known as static
aggregators.
You can create up to 96 static channel groups (and up to 32 dynamic channel
groups).
Use the no variant of this command to remove the device port from the static
channel group.
Syntax
static-channel-group <static-channel-group-number>
[member-filters]
no static-channel-group
Mode Interface Configuration
Usage This command adds the device port to the static channel group with the specified
channel group number. If the channel group does not exist, it is created, and the
port is added to it. The no prefix detaches the port from the static channel group.
If the port is the last member to be removed, the static channel group is deleted.
All the ports in a channel group must have the same VLAN configuration: they
must belong to the same VLANs and have the same tagging status, and can only
be operated on as a group.
Once the static channel group has been created, it is treated as a device port, and
can be referred to in other commands that apply to device ports.
To refer to a static channel group in other static channel group commands, use the
channel group number. To specify a static channel group in other commands,
prefix the channel group number with sa. For example, ‘sa2’ refers to the static
channel group with channel group number 2.
Examples To define static channel group 2 on a device port, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# static-channel-group 2
Parameter Description
<static-channel-
group-number>
<1-96> Static channel group number.
member-filters Allow QoS and ACL settings to be configured on the
aggregator’s individual member ports, instead of the
aggregator itself. This configuration is required when using
QoS Storm Protection on a static aggregator.
To Next Page
Loading...
Need help?
General
