28
C613-50100-01 REV C Command Reference for x930 Series 1151
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP and BGP4+
Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
the Border Gateway Protocol for IPv4 (BGP) and for IPv6 (BGP4+).
For basic BGP and BGP4+ introduction information and configuration examples,
see the BGP Feature Overview and Configuration Guide.
Command List •“address-family” on page 1157
•“aggregate-address” on page 1159
•“auto-summary (BGP only)” on page 1162
•“bgp aggregate-nexthop-check” on page 1163
•“bgp always-compare-med” on page 1164
•“bgp bestpath as-path ignore” on page 1165
•“bgp bestpath compare-confed-aspath” on page 1166
•“bgp bestpath compare-routerid” on page 1167
•“bgp bestpath med” on page 1168
•“bgp bestpath med remove-recv-med” on page 1170
•“bgp bestpath med remove-send-med” on page 1171
•“bgp client-to-client reflection” on page 1172
•“bgp cluster-id” on page 1173
•“bgp confederation identifier” on page 1175
•“bgp confederation peers” on page 1176
•“bgp config-type” on page 1178
•“bgp dampening” on page 1180
•“bgp default ipv4-unicast” on page 1182