C613-50100-01 REV C Command Reference for x930 Series 1879
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST HARDWARE IP PROTOCOL FILTER)
(access-list hardware IP protocol filter)
Overview Use this ACL filter to add an IP protocol type filter entry to the current hardware
access-list. The filter will match on any IP packet that has the specified source and
destination IP addresses and IP protocol type, or has the optionally specified
source and destination MAC addresses. The parameter any may be specified if an
address does not matter. If a sequence number is specified, the new filter is
inserted at the specified location. Otherwise, the new filter is added at the end of
the access-list.
The no variant of this command removes an IP protocol type filter entry from the
current hardware access-list. You can specify the IP protocol type filter entry for
removal by entering either its sequence number (e.g. no 10), or by entering its IP
protocol type filter profile without specifying its sequence number.
Note that the sequence number can be found by running the show access-list (IPv4
Hardware ACLs) command.
Syntax
[any|ip|proto]
[<sequence-number>]
{deny|permit|send-to-cpu|copy-to-cpu|copy-to-mirror}
{any|ip|proto <ip-protocol>}
{<source>|dhcpsnooping|any} {<destination>|any}
[mac {<mac-source-address> <mac-source-mask>|any]
{<mac-destination-address> <mac-destination-mask>|any}
no {deny|permit|send-to-cpu|copy-to-cpu|copy-to-mirror}
{any|ip|proto <ip-protocol>}
{<source>|dhcpsnooping} {<destination>|any}
[mac {<mac-source-address> <mac-source-mask>|any]
{<mac-destination-address> <mac-destination-mask>|any}
no <sequence-number>
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the selected
access control list.
deny Access-list rejects packets of the type specified.
permit Access-list allows packets of the type specified
send to cpu Specify packets to send to the CPU.
copy to cpu Specify packets to copy to the CPU.
copy to mirror Specify packets to copy to the mirror port.
ip IP packets.
any Any packet.
To Next Page
Loading...
Need help?
General
