C613-50100-01 REV C Command Reference for x930 Series 1880
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST HARDWARE IP PROTOCOL FILTER)
proto <ip-protocol> <1-255>
Specify IP protocol number, as defined by IANA (Internet
Assigned Numbers Authority
www.iana.org/assignments/protocol-numbers)
See below for a list of IP protocol numbers and their
descriptions.
dhcpsnooping The source address learned from the DHCP Snooping
binding database.
<source> The source address of the packets. You can specify a
single host, a subnet, or all sources. The following are the
valid formats for specifying the source:
any Matches any source IP address.
host<ip-addr> Matches a single source host with
the IP address given by <ip-
addr> in dotted decimal
notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any source
IP address within the specified
subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255 is
the same as entering
192.168.1.1/24.
<destination> The destination address of the packets. You can specify a
single host, a subnet, or all destinations. The following
are the valid formats for specifying the destination:
any Matches any destination IP
address.
host<ip-addr> Matches a single destination host
with the IP address given by
<ip-addr> in dotted decimal
notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any
destination IP address within the
specified subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255 is
the same as entering
192.168.1.1/24.
Parameter Description
To Next Page
Loading...
Need help?
General
