C613-50100-01 REV C Command Reference for x930 Series 1816
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE MROUTE DETAIL
show ipv6 pim sparse-mode mroute detail
Overview This command displays detailed entries of the IPv6 multicast routing table, or
detailed entries of the IPv6 multicast routing table based on the specified IPv6
address or addresses.
Two group IPv6 addresses cannot be used simultaneously; two IPv6 source
addresses cannot be used simultaneously.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 pim sparse-mode mroute
[<group-IPv6-address>|<source-IPv6-address>] detail
show ipv6 pim sparse-mode mroute [<group-IPv6-address>
<source-IPv6-address>] detail
show ipv6 pim sparse-mode mroute [<source-IPv6-address>
<group-IPv6-address>] detail
Usage Based on the group and source IPv6 address, the output is the selected route if
present in the multicast route tree.
Mode User Exec and Privileged Exec
Examples
awplus# show ipv6 pim sparse-mode mroute detail
awplus# show ipv6 pim sparse-mode mroute 2001:db8:: detail
awplus# show ipv6 pim sparse-mode mroute 2001:db8:: 2002:db8::
detail
Figure 35-8: Example output from the show ipv6 pim sparse-mode mroute
detail command
Parameter Description
<group-IPv6-address> Group IPv6 address, entered in the form X:X::X:X.
Output is all multicast entries belonging to that group.
<source-IPv6-address> Source IPv6 address, entered in the form X:X::X:X.
Output is all multicast entries belonging to that source.
detail Show detailed information.
To Next Page
Loading...
Need help?
General
