C613-50100-01 REV C Command Reference for x930 Series 1623
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP SSM-MAP ENABLE
ip igmp ssm-map enable
Overview Use this command to enable Source Specific Multicast (SSM) mapping on the
device.
Use the no variant of this command to disable SSM mapping.
Syntax
ip igmp ssm-map enable
no ip igmp ssm-map enable
Mode Global Configuration
Usage This command applies to VLAN interfaces configured for IGMP.
Example To enable SSM on the device enter the commands:
awplus# configure terminal
awplus(config)# ip igmp ssm-map enable
Related
Commands
ip igmp ssm-map static
To Next Page
Loading...
