Allied Telesis AlliedWare Plus - Chapter 50: Openflow Commands; Introduction; Openflow Commands

50
C613-50100-01 REV C Command Reference for x930 Series 2406
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OpenFlow
Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
OpenFlow.
The table below lists the OpenFlow commands and their applicable modes.
Figure 50-1: OpenFlow commands and applicable modes
Command List •“openflow” on page 2408
•“openflow controller” on page 2409
•“openflow native vlan” on page 2410
•“openflow version” on page 2411
•“show openflow config” on page 2412
•“show openflow coverage” on page 2414
•“show openflow flows” on page 2416
Mode Command
User Exec/Privileged
Exec
show openflow config
show openflow coverage
show openflow flows
show openflow rules
show openflow status
Global Configuration openflow controller
openflow native vlan
openflow version
Port Interface openflow