Allied Telesis AlliedWare Plus - Lldp Notification-Interval

C613-50100-01 REV C Command Reference for x930 Series 2883
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LLDP
NOTIFICATION-INTERVAL
lldp notification-interval
Overview This command sets the notification interval. This is the minimum interval between
LLDP SNMP notifications (traps) of each kind (LLDP Remote Tables Change
Notification and LLDP-MED Topology Change Notification).
The no variant of this command sets the notification interval back to its default.
Syntax
lldp notification-interval <5-3600>
no lldp notification-interval
Default The default notification interval is 5 seconds.
Mode Global Configuration
Examples To set the notification interval to 20 seconds, use the commands:
awplus# configure terminal
awplus(config)# lldp notification-interval 20
To set the notification interval back to its default, use the commands:
awplus# configure terminal
awplus(config)# no lldp notification-interval
Related
Commands
lldp notifications
show lldp
Parameter Description
<5-3600> The interval in seconds.