C613-50100-01 REV C Command Reference for x930 Series 3050
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PING-POLLING COMMANDS
SAMPLE
-SIZE
sample-size
Overview This command sets the total number of pings that the polling instance inspects
when determining whether a device is unreachable. If the number of pings
specified by the fail-count command go unanswered within the inspected
sample, then the device is declared unreachable.
If the numbers set in this command and fail-count command are the same, the
unanswered pings must be consecutive. If the number set by this command is
greater than that set with the fail-count command, a device that does not always
reply to pings may be declared unreachable.
You cannot set this command’s value lower than the fail-count value.
The polling instance uses the number of pings specified by the up-count
command to determine when a device is reachable.
The no variant of this command resets this command to the default.
Syntax
sample-size <1-100>
no sample size
Default The default is 5.
Mode Ping-Polling Configuration
Examples To set the sample-size to 50 for ping-poll instance 43, use the commands:
awplus# configure terminal
awplus(config)# ping-poll 43
awplus(config-ping-poll)# sample-size 50
To reset sample-size to the default of 5 for ping-poll instance 43, use the
commands:
awplus# configure terminal
awplus(config)# ping-poll 43
awplus(config-ping-poll)# no sample-size
Parameter Description
<1-100> Number of pings that determines critical and up counts.
To Next Page
Loading...
Need help?
General
