C613-50100-01 REV C Command Reference for x930 Series 2453
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
STACK
RENUMBER
stack renumber
Overview Use this command to renumber a specific stack member.
Syntax
stack <existing stack-ID> renumber <new stack-ID>
Default Every stack unit will initially try to use a stack-ID of 1.
Mode Global Configuration
Usage This command is used to change the ID of a specific stack member - primarily when
exchanging stack members. The changes made by this command will not take
effect until the switch is rebooted.
NOTE: This command does not alter any of the stacks's existing configuration, apart
from the stack-ID specified. For example, if stack member 2 were removed from the
stack and a new stack unit is assigned the member 2 stack-ID, then the interface
configuration that existed for the removed stack member 2 will be applied to the new
stack member 2.
The existing stack-ID must already be assigned to an existing stack member. To
avoid duplicating IDs, a warning message will appear if you assign a new stack-ID
that is currently assigned to another stack member. However, you can continue to
renumber the stack-IDs and remove ID duplications. If you do not remove the
duplications, then one of the devices will be forced to automatically renumber to
an unused ID. Once you have removed any duplicate IDs, you can reboot the
switch to implement your changes.
Note that the configured stack-ID is saved immediately on the renumbered
member, and so is not reliant on using the copy running-config command for it to
take effect.
Example To renumber stack 1 to stack 2, use the commands:
awplus# configure terminal
awplus(config)# stack 1 renumber 2
Validation
Command
show stack
Parameter Description
<existing stack-ID> Enter the existing stack-ID in the range 1 to 8.
renumber Change the existing stack-ID.
<new stack-ID> Enter the new stack-ID in the range 1 to 8.
To Next Page
Loading...
Need help?
General
