C613-50100-01 REV C Command Reference for x930 Series 484
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
INTERFACE SWITCHPORT
show interface switchport
Overview Use this command to show VLAN information about each switch port.
Syntax
show interface switchport
Mode User Exec and Privileged Exec
Example To display VLAN information about each switch port, enter the command:
awplus# show interface switchport
Output Figure 14-3: Example output from the show interface switchport command
Related
Commands
show interface memory
Interface name : port1.0.1
Switchport mode : access
Ingress filter : enable
Acceptable frame types : all
Default Vlan : 2
Configured Vlans : 2
Interface name : port1.0.2
Switchport mode : trunk
Ingress filter : enable
Acceptable frame types : all
Default Vlan : 1
Configured Vlans : 1 4 5 6 7 8
...
To Next Page
Loading...
