EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1776 background imageLoading...
Page #1776 background image
C613-50100-01 REV C Command Reference for x930 Series 1776
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
IPV
6 PIM ANYCAST-RP
ipv6 pim anycast-rp
Overview Use this command to configure Anycast RP (Rendezvous Point) in an RP set.
Use the no variant of this command to remove the configuration.
Syntax
ipv6 pim anycast-rp <anycast-rp-address> <member-rp-address>
no ipv6 pim anycast-rp <anycast-rp-address>
[<member-rp-address>]
Mode Global Configuration
Usage Anycast is a network addressing and routing scheme where data is routed to the
nearest or best destination as viewed by the routing topology. Compared to
unicast with a one-to- one association between network address and network
endpoint, and multicast with a one-to-many association between network address
and network endpoint; anycast has a one-to-many association between network
address and network endpoint. For anycast, each destination address identifies a
set of receiver endpoints, from which only one receiver endpoint is chosen.
Anycast is often implemented using BGP to simultaneously advertise the same
destination IPv6 address range from many sources, resulting in packets address to
destination addresses in this range being routed to the nearest source announcing
the given destination IPv6 address.
Use this command to specify the Anycast RP configuration in the Anycast RP set.
Use the no variant of this command to remove the Anycast RP configuration. Note
that the member RP address is optional when using the no parameter to remove
the Anycast RP configuration. removing the anycast RP address also removes the
member RP address.
Examples The following example shows how to configure the Anycast RP address with ipv6
pim anycast-rp:
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim anycast-rp 2:2::2:2 20:20::20:20
Parameter Description
<anycast-rp-address> <X:X::X:X> Specify an Anycast IPv6 address to configure
an Anycast RP (Rendezvous Point) in a RP set.
<member-rp-address> <A:B::C:D> Specify an Anycast RP (Rendezvous
Point)IPv6 address to configure an Anycast RP in a RP set.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals