Allied Telesis AlliedWare Plus - Debug Sflow Agent

C613-50100-01 REV C Command Reference for x930 Series 3065
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SFLOW COMMANDS
DEBUG
SFLOW AGENT
debug sflow agent
Overview This command enables sFlow® debug message logging that is not specific to
particular ports. For example, sending an sFlow datagram to the collector.
The no variant of this command applies the command default.
Syntax
debug sflow agent
no debug sflow agent
Default The sFlow agent debug message logging (that is not port specific) is disabled.
Mode Privileged Exec
Example To enable logging of sFlow agent debug messages, use the following command:
awplus# debug sflow agent
Related
Commands
show debugging sflow
debug sflow