C613-50100-01 REV C Command Reference for x930 Series 1781
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
IPV
6 PIM CISCO-REGISTER-CHECKSUM GROUP-LIST
ipv6 pim cisco-register-checksum group-list
Overview Use this command to configure the option to calculate the Register Checksum
over the whole packet on multicast groups as specified by the software IPv6
access-list. This command is used to inter-operate with older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax
ipv6 pim cisco-register-checksum group-list <IPv6-access-list>
no ipv6 pim cisco-register-checksum group-list
<IPv6-access-list>
Mode Global Configuration
Default This command is disabled by default. By default, Register Checksum is calculated
only over the header.
Example
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim cisco-register-checksum group-list G1
awplus(config)# ipv6 access-list standard G1 permit
ff0x::db8:0:0/96
Parameter Description
<IPv6-access-list> Optional. Specify a Standard or Extended software IPv6
access list.
See IPv6 Software Access Control List (ACL) Commands for
supported IPv6 ACLs.
Use this parameter to configure the option to calculate the
Register Checksum over the whole packet on multicast
groups as specified by an IPv6 access list entered after this
command.
To Next Page
Loading...
Need help?
General
