C613-50100-01 REV C Command Reference for x930 Series 597
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SPANNING TREE COMMANDS
SPANNING
-TREE AUTOEDGE (RSTP AND MSTP)
spanning-tree autoedge (RSTP and MSTP)
Overview Use this command to enable the autoedge feature on the port.
The autoedge feature allows the port to automatically detect that it is an edge
port. If it does not receive any BPDUs in the first three seconds after linkup,
enabling, or entering RSTP or MSTP mode, it sets itself to be an edgeport and
enters the forwarding state.
Use this command for RSTP or MSTP.
Use the no variant of this command to disable this feature.
Syntax
spanning-tree autoedge
no spanning-tree autoedge
Default Disabled
Mode Interface Configuration
Example
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# spanning-tree autoedge
Related
Commands
spanning-tree edgeport (RSTP and MSTP)
To Next Page
Loading...
Need help?
General
