Allied Telesis AlliedWare Plus - Show Port-Security Intrusion

C613-50100-01 REV C Command Reference for x930 Series 497
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
PORT-SECURITY INTRUSION
show port-security intrusion
Overview Use this command to show the intrusion list. If the port is not specified, the entire
intrusion table is shown.
Syntax
show port-security intrusion [interface <port>]
Mode Privileged Exec
Example To see the intrusion list on port1.0.1, use the following command:
awplus# show port-security intrusion interface port1.0.1
Output Figure 14-10: Example output from the show port-security intrusion command
for port 1.0.1
Related
Commands
clear port-security intrusion
show port-security interface
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
Parameter Description
interface Specify a port
<port> The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
Port Security Intrusion List 
Interface: port1.0.1 -3 intrusion(s) detected 
11-22-33-44-55-04 11-22-33-44-55-06 11-22-33-44-55-08