C613-50100-01 REV C Command Reference for x930 Series 1291
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
FILTER-LIST
neighbor filter-list
Overview This command creates a BGP or BGP4+ filter using an AS (Autonomous System)
path list. This command specifies an AS path list, which it then applies to filter
updates to and from a BGP or a BGP4+ neighbor
The no variant of this command removes the previously specified BGP or BGP4+
filter using access control lists.
Syntax
neighbor <neighborid> filter-list <listname> {in|out}
no neighbor <neighborid> filter-list <listname> {in|out}
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
Usage This command specifies a filter for updates based on a BGP AS (Autonomous
System) path list.
Parameter Description
<neighborid> Specify the identification method for the BGP or BGP4+ peer. Use
one of the following formats:
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) command, and neighbor route-map
command. When this parameter is used with
this command, the command applies on all
peers in the specified group.
<listname> Specify the name of an AS (Autonomous System) path list.
in Indicates that incoming advertised routes will be filtered.
out Indicates that outgoing advertised routes will be filtered.
To Next Page
Loading...
Need help?
General
