C613-50100-01 REV C Command Reference for x930 Series 1897
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST EXTENDED (NAMED)
access-list extended (named)
Overview This command configures an extended named access-list that permits or denies
packets from specific source and destination IP addresses. You can either create an
extended named ACL together with an ACL filter entry in the Global Configuration
mode, or you can use the IPv4 Extended ACL Configuration mode for sequenced
ACL filter entry after entering a list name.
The no variant of this command removes a specified extended named access-list.
Syntax
[list-name]
access-list extended <list-name>
no access-list extended <list-name>
Syntax [icmp] access-list extended <list-name>{deny|permit} icmp <source>
<destination> [icmp-type <type-number>] [log]
no access-list extended <list-name>{deny|permit} icmp <source>
<destination> [icmp-type <type-number>] [log]
Parameter Description
<list-name> A user-defined name for the access-list
Table 38-2: Parameters in the access-list extended (named) command - icmp
Parameter Description
<list-name> A user-defined name for the access-list.
deny The access-list rejects packets that match the type, source, and
destination filtering specified with this command.
permit The access-list permits packets that match the type, source, and
destination filtering specified with this command.
icmp The access-list matches only ICMP packets.
icmp-type Matches only a specified type of ICMP messages. This is valid only
when the filtering is set to match ICMP packets.
To Next Page
Loading...
Need help?
General
