EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1071 background imageLoading...
Page #1071 background image
C613-50100-01 REV C Command Reference for x930 Series 1071
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
AREA
VIRTUAL-LINK AUTHENTICATION IPSEC SPI
area virtual-link authentication ipsec spi
Overview Use this command in Router Configuration mode to enable authentication for
virtual links in a specified OSPF area.
Use the no variant of this command in Router Configuration mode to disable
authentication for virtual links in a specified OSPF area.
Syntax
area <area-id> virtual-link <router-ID> authentication ipsec
spi <256-4294967295> {md5 <MD5-key>|sha1 <SHA1-key>}
no area <area-id> virtual-link <router-ID> authentication ipsec
spi <256-4294967295>
Mode Router Configuration
Usage Use this command on an OSPFv3 area virtual link, use the area authentication ipsec
spi command on an OSPFv3 area. Configure the same SPI (Security Parameters
Index) value on all interfaces that connect to the same link. SPI values are used by
Parameter Description
<area-id> The OSPF area that you are specifying the summary route
default-cost for. This can be entered in either dotted decimal
format or normal decimal format. Use one of the following
formats:
<ip-addr> OSPF area-ID expressed in IPv4 address
format A.B.C.D.
<0-
4294967295>
OSPF area-ID expressed as a decimal
number within the range shown.
For example, the values 0.0.1.2 and decimal 258 would both
define the same area-ID.
virtual-link Specify a virtual link and its parameters.
<router-ID> Enter a router ID associated with a virtual link neighbor in IPv4
address format A.B.C.D.
authentication Specify this keyword to enable authentication.
ipsec Specify this keyword to use IPsec authentication.
spi Specify this keyword to set the SPI (Security Parameters Index).
<256-
4294967295>
Specify an SPI (Security Parameters Index) value in the range 256
to 4294967295, entered as a decimal integer.
md5 Specify the MD5 (Message-Digest 5) encryption algorithm.
<MD5-key> Enter an MD5 key containing 32 hexadecimal characters.
sha1 Specify the SHA-1 (Secure Hash Algorithm 1) encryption
algorithm.
<SHA1-key> Enter an SHA-1 key containing 40 hexadecimal characters.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals