C613-50100-01 REV C Command Reference for x930 Series 2562
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
DISTRIBUTE FIRMWARE
atmf distribute firmware
Overview This command can be used to upgrade software one AMF node at a time. A URL
can be selected from any media location. The latest compatible release for a node
will be selected from this location.
Several procedures are performed to ensure the upgrade will succeed. This
includes checking the current node release boots from flash. If there is enough
space on flash the software release is copied to flash on the new location.
The new release name is updated using the boot system command. The old release
will become the backup release file. If a release file exists in a remote device (such
as TFTP or HTTP, for example) then the URL should specify the exact release
filename without using a wild card character.
The command will continue to upgrade software until all nodes are upgraded. At
the end of the upgrade cycle the command should be used on the working-set.
Syntax
atmf distribute firmware <filename>
Mode Privileged Exec
Examples To upgrade nodes in a AMF network with a predefined AMF group called “teams”,
use the following commands:
Team1# atmf working-set group teams
ATMF_NETWORK[3]# atmf distribute firmware card:*.rel
Parameter Description
<filename> The filename and path of the file. See the File Management Feature
Overview and Configuration Guide for valid syntax.
=============================
Team1, Team2, Team3:
=============================
Working set join
To Next Page
Loading...
Need help?
General
