C613-50100-01 REV C Command Reference for x930 Series 529
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
SWITCHPORT
MODE PRIVATE-VLAN
switchport mode private-vlan
Overview Use this command to make a Layer 2 port a private VLAN host port or a
promiscuous port.
Use the no variant of this command to remove the configuration.
Syntax
switchport mode private-vlan {host|promiscuous}
no switchport mode private-vlan {host|promiscuous}
Mode Interface Configuration
Examples
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport mode private-vlan host
awplus(config)# interface port1.0.3
awplus(config-if)# switchport mode private-vlan promiscuous
awplus(config)# interface port1.0.4
awplus(config-if)# no switchport mode private-vlan promiscuous
Related
Commands
switchport private-vlan mapping
Parameter Description
host This port type can communicate with all other host ports assigned to
the same community VLAN, but it cannot communicate with the
ports in the same isolated VLAN. All communications outside of this
VLAN must pass through a promiscuous port in the associated
primary VLAN.
promiscuous A promiscuous port can communicate with all interfaces, including
the community and isolated ports within a private VLAN.
To Next Page
Loading...
Need help?
General
