C613-50100-01 REV C Command Reference for x930 Series 1769
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
CLEAR
IPV6 PIM SPARSE-MODE BSR RP-SET *
clear ipv6 pim sparse-mode bsr rp-set *
Overview Use this command to clear all Rendezvous Point (RP) sets learned through the
PIM-SMv6 Bootstrap Router (BSR).
NOTE: Static IPv6 multicast routes take priority over dynamic IPv6 multicast routes. Use
the clear ipv6 mroute command to clear static IPv6 multicast routes and ensure
dynamic IPv6 multicast routes can take over from previous static IPv6 multicast routes.
Syntax
clear ipv6 pim sparse-mode bsr rp-set *
Mode Privileged Exec
Usage For multicast clients, note that one router will be automatically or statically
designated as the RP, and all routers must explicitly join through the RP. A
Designated Router (DR) sends periodic Join/Prune messages toward a
group-specific RP for each group that it has active members.
For multicast sources, note that the Designated Router (DR) unicasts Register
messages to the RP encapsulating the data packets from the multicast source. The
RP forwards decapsulated data packets toward group members.
Example
awplus# clear ipv6 pim sparse-mode bsr rp-set *
Parameter Description
* Clears all RP sets.
To Next Page
Loading...
Need help?
General
