C613-50100-01 REV C Command Reference for x930 Series 131
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
COPY
STARTUP-CONFIG
copy startup-config
Overview This command copies the startup-config script into a destination file, or
alternatively copies a configuration script from a source file into the startup-config
file. Specify whether the destination is Flash or USB when loading from the local
filesystem.
Syntax
copy <source-name> startup-config
copy startup-config <destination-name>
Mode Privileged Exec
Examples To copy the file Layer3.cfg to the startup-config, use the command:
awplus# copy Layer3.cfg startup-config
To copy the startup-config as the file oldconfig.cfg in the current
directory, use the command:
awplus# copy startup-config oldconfig.cfg
Related
Commands
copy running-config
Parameter Description
<source-name> The filename and path of a configuration file. This must be
a valid configuration file with a . cfg filename extension.
Specify this to copy the script in the file into the startup-
config file. Note that this does not make the copied file the
new startup file, so any further changes made in the
configuration file are not added to the startup-config file
unless you reuse this command. See Introduction on page
114 for valid syntax.
<destination-name> The destination and filename that you are saving the
startup- config as. This command creates a file if no file
exists with the specified filename. If a file already exists,
then the CLI prompts you before overwriting the file. See
Introduction on page 114 for valid syntax.
To Next Page
Loading...
