C613-50100-01 REV C Command Reference for x930 Series 2731
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SERVICE
DHCP-RELAY
service dhcp-relay
Overview This command enables the DHCP Relay Agent on the device. However, on a given
IP interface, no DHCP forwarding takes place until at least one DHCP server is
specified to forward/relay all clients’ DHCP packets to.
The no variant of this command disables the DHCP Relay Agent on the device for
all interfaces.
Syntax
service dhcp-relay
no service dhcp-relay
Mode Global Configuration
Usage A maximum number of 400 DHCP Relay Agents (one per interface) can be
configured on the device. Once this limit has been reached, any further attempts
to configure DHCP Relay Agents will not be successful.
Default The DHCP-relay service is enabled by default.
Examples To enable the DHCP relay global function, use the commands:
awplus# configure terminal
awplus(config)# service dhcp-relay
To disable the DHCP relay global function, use the commands:
awplus# configure terminal
awplus(config)# no service dhcp-relay
Related
Commands
ip dhcp-relay agent-option
ip dhcp-relay agent-option checking
ip dhcp-relay information policy
ip dhcp-relay maxhops
ip dhcp-relay server-address
To Next Page
Loading...
Need help?
General
