C613-50100-01 REV C Command Reference for x930 Series 676
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
POWER OVER ETHERNET COMMANDS
SERVICE
POWER-INLINE
service power-inline
Overview This command enables Power over Ethernet (PoE) globally on the switch, for all
PoE ports.
Syntax
service power-inline
no service power-inline
Default PoE functionality is enabled by default
Mode Global Configuration
Usage In a stack, issuing this command enables PoE globally for all PoE ports.
In a stack configuration, only stack members containing PoE hardware will have
PoE enabled by default in software.
Examples To disable PoE, use the following commands:
awplus# configure terminal
awplus(config)# no service power-inline
To re-enable PoE, if PoE has been disabled, use the following commands:
awplus# configure terminal
awplus(config)# service power-inline
Related
Commands
show power-inline
show running-config power-inline
To Next Page
Loading...
