C613-50100-01 REV C Command Reference for x930 Series 3019
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
TRAP
trap
Overview This command enables the specified trigger to send SNMP traps.
Use the no variant of this command to disable the sending of SNMP traps from the
specified trigger.
Syntax
trap
no trap
Default SNMP traps are enabled by default for all defined triggers.
Mode Trigger Configuration
Usage You must configure SNMP before using traps with triggers. For more information,
see:
• Support for Allied Telesis Enterprise_MIBs_in_AlliedWare Plus, for
information about which MIB objects are supported.
•the SNMP Feature Overview and Configuration_Guide.
•the SNMP Commands chapter.
Since SNMP traps are enabled by default for all defined triggers, a common usage
will be for the no variant of this command to disable SNMP traps from a specified
trap if the trap is only periodic. Refer in particular to AT-TRIGGER-MIB in the
Support for Allied Telesis Enterprise_MIBs_in AlliedWare Plus for further
information about the relevant SNMP MIB.
Examples To enable SNMP traps to be sent from trigger 5, use the commands:
awplus# configure terminal
awplus(config)# trigger 5
awplus(config-trigger)# trap
To disable SNMP traps being sent from trigger 205, use the commands:
awplus# configure terminal
awplus(config)# trigger 205
awplus(config-trigger)# no trap
Related
Commands
trigger
show trigger
To Next Page
Loading...
Need help?
General
