C613-50100-01 REV C Command Reference for x930 Series 2408
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OPENFLOW COMMANDS
OPENFLOW
openflow
Overview Use this command to specify a port as a data plane port. The ingress and egress
traffic on the data plane port become controlled by the OpenFlow Controller. A
data plane port number is assigned to the port automatically.
Use the no variant of this command to cancel the setting of a port as a data plane
port. After entering the no variant of this command, you must restart the switch.
Syntax
openflow
no openflow
Default All the ports are non-data plane ports by default.
Mode Port Interface mode
Example To specify port1.0.3 as a data plane port:
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# openflow
Related
Commands
show openflow config
To Next Page
Loading...
