EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2722 background imageLoading...
Page #2722 background image
C613-50100-01 REV C Command Reference for x930 Series 2722
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
NEXT
-SERVER
next-server
Overview This command sets the next server address for a DHCP server pool. It is the address
of the next server that the client should use in its bootstrap process.
The no variant of this command removes the next server address from the DHCP
address pool.
Syntax
next-server <ip-address>
no next-server
Mode DHCP Configuration
Example To set the next-server address for the address pool P2, use the commands:
awplus# configure terminal
awplus(config)# ip dhcp pool P2
awplus(dhcp-config)# next-server 192.0.2.2
Parameter Description
<ip-address> The server IP address, entered in dotted decimal notation.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals