C613-50100-01 REV C Command Reference for x930 Series 2257
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RADIUS COMMANDS
RADIUS
-SERVER DEADTIME
radius-server deadtime
Overview Use this command to specify the global deadtime for all RADIUS servers. If a
RADIUS server is considered dead, it is skipped for the specified deadtime. This
command specifies for how many minutes a RADIUS server that is not responding
to authentication requests is passed over by requests for RADIUS authentication.
Use the no variant of this command to reset the global deadtime to the default of
0 seconds, so that RADIUS servers are not skipped even if they are dead.
Syntax
radius-server deadtime <minutes>
no radius-server deadtime
Default The default RADIUS deadtime configured on the system is 0 seconds.
Mode Global Configuration
Usage The RADIUS client considers a RADIUS server to be dead if it fails to respond to a
request after it has been retransmitted as often as specified globally by the
radius-server retransmit command or for the server by the radius-server host
command. To improve RADIUS response times when some servers may be
unavailable, set a deadtime to skip dead servers.
Examples To set the dead time of the RADIUS server to 60 minutes, use the following
commands:
awplus# configure terminal
awplus(config)# radius-server deadtime 60
To disable the dead time of the RADIUS server, use the following commands:
awplus# configure terminal
awplus(config)# no radius-server deadtime
Related
Commands
deadtime (RADIUS server group)
radius-server host
radius-server retransmit
show radius statistics
Parameter Description
<minutes> RADIUS server deadtime in minutes in the range 0 to 1440 (24 hours).
To Next Page
Loading...
Need help?
General
