Allied Telesis AlliedWare Plus - Auth-Web Authentication

C613-50100-01 REV C Command Reference for x930 Series 2145
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
-WEB AUTHENTICATION
auth-web authentication
Overview This command overrides the default Web-based authentication method on an
interface by allowing you to apply a user-defined named list.
Use the no variant of this command to remove the named list from the interface
and apply the default method.
Syntax
auth-web authentication {default|<list-name>}
no auth-web authentication
Default The default method list is applied to an interface by default.
Mode Interface Mode
Example To apply the named list 'vlan10_auth' on the vlan10 interface, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# auth-web authentication vlan10_auth
To remove the named list from the vlan10 interface and set the authentication
method back to default, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# no auth-web authentication
Related
Commands
aaa authentication auth-web
Parameter Description
default Apply the default authentication method list
<list-name> Apply the user-defined named list