C613-50100-01 REV C Command Reference for x930 Series 2878
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LLDP
MED-NOTIFICATIONS
lldp med-notifications
Overview Use this command to enable LLDP to send LLDP-MED Topology Change Detected
SNMP notifications relating to the specified ports. The switch sends an SNMP event
notification when a new LLDP-MED compliant IP Telephony device is connected to
or disconnected from a port on the switch.
Use the no variant of this command to disable the sending of LLDP-MED Topology
Change Detected notifications relating to the specified ports.
Syntax
lldp med-notifications
no lldp med-notifications
Default The sending of LLDP-MED notifications is disabled by default.
Mode Interface Configuration
Examples To enable the sending of LLDP-MED Topology Change Detected notifications
relating to ports 1.0.1 and 1.0.6, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# lldp med-notifications
To disable the sending of LLDP-MED notifications relating to ports 1.0.1 and 1.0.6,
use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-notifications
Related
Commands
lldp notification-interval
lldp notifications
snmp-server enable trap
show lldp interface
To Next Page
Loading...
Need help?
General
