C613-50100-01 REV C Command Reference for x930 Series 304
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PLUGGABLES AND CABLING COMMANDS
DEBUG
FIBER-MONITORING
debug fiber-monitoring
Overview Use this command to enable debugging of active fiber monitoring on the specified
ports.
Use the no variant of this command to disable debugging on all ports or the
specified ports.
Syntax
debug fiber-monitoring interface <port-list>
no debug fiber-monitoring [interface <port-list>]
Default Debugging of active fiber monitoring is disabled by default.
Mode User Exec/Privileged Exec
Usage While debugging is enabled by this command for a port, all the optical power
readings for the port are sent to the console.
Example To enable debugging messages for active fiber monitoring of port 1.0.2 to be sent
to the console, use the commands:
awplus# debug fiber-monitoring interface port 1.0.2
awplus# terminal monitor
To disable debugging messages for active fiber monitoring on port 1.0.2, use the
command:
awplus# no debug fiber-monitoring interface port 1.0.2
To disable all debugging messages for active fiber monitoring, use the command:
awplus# no debug fiber-monitoring
Parameter Description
<port-list> The list of fiber ports to enable or disable debugging for, as a
single port, a comma separated list or a hyphenated range.
To Next Page
Loading...
Need help?
General
