EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1604 background imageLoading...
Page #1604 background image
C613-50100-01 REV C Command Reference for x930 Series 1604
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP QUERY-HOLDTIME
ip igmp query-holdtime
Overview This command sets the time that an IGMP Querier waits after receiving a query
solicitation before it sends an IGMP Query. IGMP General Query messages will not
be sent during the hold time interval.
Use the no variant of this command to return to the default query hold time
period.
Syntax
ip igmp query-holdtime <interval>
no ip igmp query-holdtime
Default By default the delay before sending IGMP General Query messages is 500
milliseconds.
Mode Interface Configuration for a VLAN interface.
Usage Use this command to configure a value for the IGMP query hold time in the current
network. IGMP Queries can be generated after receiving Query Solicitation (QS)
packets and there is a possibility of a DoS (Denial of Service) attack if a stream of
Query Solicitation (QS) packets are sent to the IGMP Querier, eliciting a rapid
stream of IGMP Queries. This command applies to interfaces on which the device
is acting as an IGMP Querier.
Use the ip igmp query-interval command when a delay for IGMP general query
messages is required and IGMP general query messages are required. The ip igmp
query-holdtime command stops IGMP query messages during the configured
holdtime interval, so the rate of IGMP Queries that can be sent out of an interface
can be restricted.
See the IGMP Feature Overview and Configuration Guide for introductory
information about the Query Solicitation feature.
NOTE: This command will function on the switch in the stand-alone mode, but it is not
supported when the device forms part of a VCS Stack.
Examples To set the IGMP query holdtime to 900 ms for vlan20, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan20
awplus(config-if)# ip igmp query-holdtime 900
Parameter Description
<interval> Query interval value in milliseconds, in the range <100-5000>.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals