C613-50100-01 REV C Command Reference for x930 Series 2904
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LOCATION
ELIN-LOCATION-ID
location elin-location-id
Overview Use this command to assign an ELIN location to the ports. The ELIN location must
already exist. This replaces any previous assignment of ELIN location for the ports.
Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location identifier from the ports.
Syntax
location elin-location-id <elin-loc-id>
no location elin-location-id [<elin-loc-id>]
Default By default no ELIN location is assigned to ports.
Mode Interface Configuration
Usage An ELIN location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, configure the location using the location elin-location
command.
If an ELIN location is deleted using the no variant of one of the location
elin-location command, it is automatically removed from all ports.
Examples To assign ELIN location 1 to port 1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# location elin-location-id 1
To remove an ELIN location from port 1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no location elin-location-id
Related
Commands
lldp med-tlv-select
location elin-location
show location
Parameter Description
<elin-loc-id> ELIN location identifier, in the range 1 to 4095.
To Next Page
Loading...
Need help?
General
