C613-50100-01 REV C Command Reference for x930 Series 1136
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
SHOW
IPV6 OSPF NEIGHBOR
show ipv6 ospf neighbor
Overview Use this command in User Exec or Privileged Exec modes to display information on
OSPF neighbors. Include the process ID parameter with this command to display
information about specified processes.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 ospf [<process-id>] neighbor <neighbor-id>
show ipv6 ospf [<process-id>] neighbor detail
show ipv6 ospf [<process-id>] neighbor <interface> [detail]
Mode User Exec and Privileged Exec
Examples
awplus# show ipv6 ospf neighbor
Output Figure 27-14: Example output from show ipv6 ospf neighbor
Parameter Description
<process-id> <character string>
The ID of the OSPF process for which information will be
displayed.
<neighbor-id> The Neighbor ID, entered in IP address (A.B.C.D) format.
detail Detail of all neighbors.
<interface> IP address of the interface.
awplus#show ipv6 ospf P1 neighbor 2.2.2.2
OSPFv3 Process (P1)
Neighbor ID Pri State Dead Time Interface Instance ID
2.2.2.2 5 2-Way/DROther 00:00:33 vlan3 0