Allied Telesis AlliedWare Plus - Show Debugging Snmp

C613-50100-01 REV C Command Reference for x930 Series 2835
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP COMMANDS
SHOW
DEBUGGING SNMP
show debugging snmp
Overview This command displays whether SNMP debugging is enabled or disabled.
Syntax
show debugging snmp
Mode User Exec and Privileged Exec
Example To display the status of SNMP debugging, use the command:
awplus# show debugging snmp
Output Figure 58-2: Example output from the show debugging snmp command
Related
Commands
debug snmp
Snmp (SMUX) debugging status:
Snmp debugging is on