C613-50100-01 REV C Command Reference for x930 Series 1705
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
MULTICAST COMMANDS
SHOW
IP MROUTE
show ip mroute
Overview Use this command to display the contents of the IPv4 multicast routing (mroute)
table.
Syntax
show ip mroute [<ipv4-group-addr>] [<ipv4-source-addr>]
[{dense|sparse}] [{count|summary}]
Mode User Exec and Privileged Exec
Examples
awplus# show ip mroute 10.10.3.34 224.1.4.3
awplus# show ip mroute 10.10.5.24 225.2.2.2 count
awplus# show ip mroute 10.10.1.34 summary
Output The following is a sample output of this command displaying the IPv4 multicast
routing table, with and without specifying the group and source IPv4 address:
Figure 33-2: Example output from the show ip mroute command
Parameter Description
<ipv4-group-addr> Group IPv4 address, in dotted decimal notation in the
format A.B.C.D.
<ipv4-source-addr> Source IPv4 address, in dotted decimal notation in the
format A.B.C.D.
dense Display dense IPv4 multicast routes.
sparse Display sparse IPv4 multicast routes.
count Display the route and packet count from the IPv4 multicast
routing (mroute) table.
summary Display the contents of the IPv4 multicast routing (mroute)
table in an abbreviated form.
awplus# show ip mroute
IP Multicast Routing Table
Flags: I - Immediate Stat, T - Timed Stat, F - Forwarder
installed
Timers: Uptime/Stat Expiry
Interface State: Interface (TTL)
(10.10.1.52, 224.0.1.3), uptime 00:00:31, stat expires 00:02:59
Owner PIM-SM, Flags: TF
Incoming interface: vlan2
Outgoing interface list:
vlan3 (1)
To Next Page
Loading...
Need help?
General
