C613-50100-01 REV C Command Reference for x930 Series 1540
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRF LITE COMMANDS
ROUTER
-ID (VRF)
router-id (VRF)
Overview Use this command to specify a router identifier (in IP address format). When using
VRF-Lite, the router-id is configured for the specified VRF instance.
Use the no variant of this command to force OSPF to use the previous OSPF
router-id behavior.
Syntax
router-id <ip-address>
no router-id
Mode Router Configuration
Usage Configure each router with a unique router-id. In an OSPF router process that has
active neighbors, a new router-id is used at the next reload or when you restart
OSPF manually.
Example The following example shows a fixed router ID 10.10.10.60 for the VRF
instance red:
awplus# configure terminal
awplus(config)# ip vrf red
awplus(config-router)# router-id 10.10.10.60
Related
Commands
show ip ospf
show ip vrf
Parameter Description
<ip-address> Specifies the router ID in IPv4 address format.
To Next Page
Loading...
Need help?
General
