C613-50100-01 REV C Command Reference for x930 Series 1010
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
OSPF
ROUTER-ID
ospf router-id
Overview Use this command to specify a router ID for the OSPF process.
Use the no variant of this command to disable this function.
Syntax
ospf router-id <ip-address>
no ospf router-id
Mode Router Configuration
Usage Configure each router with a unique router-id. In an OSPF router process that has
active neighbors, a new router-id takes effect at the next reload or when you
restart OSPF manually.
Example The following example shows a specified router ID 2.3.4.5.
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# ospf router-id 2.3.4.5
Related
Commands
show ip ospf
Parameter Description
<ip-address> Specifies the router ID in IPv4 address format.
To Next Page
Loading...
Need help?
General
