C613-50100-01 REV C Command Reference for x930 Series 2494
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRRP COMMANDS
SHOW
VRRP (SESSION)
show vrrp (session)
Overview Use this command to display information for a particular VRRP session.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
See the VRRP Feature Overview and Configuration Guide for more information
about VRRPv3 IPv4 configuration details.
Syntax
show vrrp <vrid> <interface>
Mode User Exec and Privileged Exec
Usage See the below sample output from the show vrrp command displaying
information about VRRP session 1 configured on vlan2. Output shows that a
Virtual IP address has been set.
awplus# show vrrp 1 vlan2
See the below sample output from the show vrrp command displaying
information about VRRP session 1 configured on vlan3. Output shows a Virtual IP
address has not been set.
awplus# show vrrp 1 vlan3
Parameter Description
<vrid> <1-255> The virtual router ID for which to display information.
Session must already exist.
<interface> The interface to display information about, for instance, vlan2.
awplus#show vrrp 1 vlan2
Address family IPv4
VrId <1>
Interface is vlan2
State is Initialize
Virtual IP address is 10.10.11.250 (Not IP owner)
Priority is 100
Advertisement interval is 1 sec
To Next Page
Loading...
Need help?
General
