C613-50100-01 REV C Command Reference for x930 Series 221
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
GUI COMMANDS
ATMF
TOPOLOGY-GUI ENABLE
atmf topology-gui enable
Overview Use this command to enable the operation of AMF Vista Manager on the Master
device.
Use the no variant of this command to disable this feature.
Syntax
atmf topology-gui enable
no atmf topology-gui enable
Default By default the GUI support will not be enabled on AMF Master devices. An AMF
Controller device will have the GUI enabled by default. Regular nodes (not master
or controller) will always have it disabled.
Mode Global Configuration mode
Usage This command is run from an AMF Master node. Topology information about your
network is displayed in the GUI. For example; Node Name, status (i.e. link state,
node status and recovery status), Role (i.e. Master or Controller) and IP address.
Example To enable AMF Vista Manager on Node1, use the following commands:
Node1# configure terminal
Node1(config)# atmf topology-gui enable
To disable AMF Vista Manager on Node1, use the following commands:
Node1# configure terminal
Node1(config)# no atmf topology-gui enable
Related
Commands
atmf enable
gui-timeout
log event-host
service http
To Next Page
Loading...
Need help?
General
