EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1172 background imageLoading...
Page #1172 background image
C613-50100-01 REV C Command Reference for x930 Series 1172
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
BGP
CLIENT-TO-CLIENT REFLECTION
bgp client-to-client reflection
Overview This command restores route reflection from a BGP route reflector to clients, and is
used to configure routers as route reflectors. Route reflectors are used when all
Interior Border Gateway Protocol (iBGP) speakers are not fully meshed.
If the clients are fully meshed the route reflector is not required, use the no variant
of this command to disable the client-to-client route reflection.
When a router is configured as a route reflector, client-to-client reflection is
enabled by default.
The no variant of this command turns off client-to-client reflection.
Syntax
bgp client-to-client reflection
no bgp client-to-client reflection
Default This command is enabled by default.
Mode Router Configuration
Example
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# no bgp client-to-client reflection
Related
Commands
bgp cluster-id
neighbor route-reflector-client (BGP only)
show bgp ipv6 (BGP4+ only)
show ip bgp (BGP only)

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals