Allied Telesis AlliedWare Plus - Undebug Ipv6 Pim Sparse-Mode

C613-50100-01 REV C Command Reference for x930 Series 1825
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
UNDEBUG
IPV6 PIM SPARSE-MODE
undebug ipv6 pim sparse-mode
Overview Use this command to deactivate PIM-SMv6 debugging. Note that this command is
an alias of the no variant of the debug ipv6 pim sparse-mode command.
Syntax
undebug ipv6 pim sparse-mode [all] [events] [mfc] [mib]
[nexthop] [nsm] [state] [timer]
Mode Privileged Exec and Global Configuration
Example
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# undebug ipv6 pim sparse-mode all
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# undebug ipv6 pim sparse-mode events
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# undebug ipv6 pim sparse-mode nexthop
Parameter Description
all Deactivates all PIM-SMv6 debugging.
events Deactivates debug printing of PIM-SMv6 events.
mfc Deactivates debug printing of MFC (Multicast Forwarding Cache).
mib Deactivates debug printing of PIM-SMv6 MIBs.
nexthop Deactivates debug printing of PIM-SMv6 next hop communications.
nsm Deactivates debugging of PIM-SMv6 NSM (Network Services Module)
communications.
state Deactivates debug printing of state transition on all PIM-SMv6 FSMs.
timer Deactivates debug printing of PIM-SMv6 timers.