C613-50100-01 REV C Command Reference for x930 Series 1611
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP ROBUSTNESS-VARIABLE
ip igmp robustness-variable
Overview Use this command to change the robustness variable value on an interface.
Use the no variant of this command to return to the default on an interface.
Syntax
ip igmp robustness-variable <1-7>
no ip igmp robustness-variable
Default The default robustness variable value is 2.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to interfaces configured for IGMP and IGMP Snooping.
Examples To set the robustness variable to 3 on vlan20, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan20
awplus(config-if)# ip igmp robustness-variable 3
Related
Commands
show ip igmp interface
show running-config
Parameter Description
<1-7> The robustness variable value.
To Next Page
Loading...
Need help?
General
