C613-50100-01 REV C Command Reference for x930 Series 2630
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF AREA NODES-DETAIL
show atmf area nodes-detail
Overview Use this command to display detailed information about an AMF controller’s
remote nodes.
Note that this command can only be run from a controller node.
Syntax
show atmf area nodes-detail [<area-name> [<node-name>]]
Mode Privileged Exec
Usage If you do not limit the output to a single area or node, this command displays
information about all remote nodes that the controller is aware of. This can be a
very large number of nodes.
Example To show information about all the nodes the controller is aware of, use the
command:
controller-1# show atmf area nodes-detail
The following figure shows partial example output from running this command.
Parameter Description
<area-name> Displays detailed information about nodes in the specified area.
<node-name> Displays detailed information about the specified node.
Table 13: Output from the show atmf area nodes-detail command
controller-1#show atmf area nodes-detail
Wellington Area Node Information:
Node name well-gate
Parent node name : well-master
Domain id : well-gate’s domain
Board type : 368
Distance to core : 1
Flags : 50
Extra flags : 0x00000006
MAC Address : 001a.eb56.9020
Node name well-master
Parent node name : none
Domain id : well-master’s domain
Board type : 333
Distance to core : 0
Flags : 51
Extra flags : 0x0000000c
MAC Address : eccd.6d3f.fef7
...
To Next Page
Loading...
