Allied Telesis AlliedWare Plus - Show Stack Indicator

C613-50100-01 REV C Command Reference for x930 Series 2445
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
SHOW
STACK INDICATOR
show stack indicator
Overview This command enables you to physically identify a specific stack member. This
command will flash the Master Status LED for the stack member specified. The
pattern will be a number of flashes in quick succession followed by a longer pause;
where the number of flashes equals the stack member ID.
Syntax
show stack indicator [<stack-member>|all] [timeout
<timeout-period>]
Mode User Exec and Privileged Exec
Examples To find stack member 2 by flashing its Master Status LED, use the command:
awplus# show stack indicator 2
To find stack member 2 by flashing its Master Status LED for 1 minute, use the
command:
awplus# show stack indicator 2 timeout 60
Parameter Description
<stack-member> The ID of the stack member to be identified (1-8).
Default is All.
all Will flash the Master Status LED on each stack member with
its own appropriate ID pattern.
<timeout-period> The time period (in seconds) that the indication will display.
Default is 30 seconds.