C613-50100-01 REV C Command Reference for x930 Series 399
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LOGGING COMMANDS
SHOW
LOG CONFIG
show log config
Overview This command displays information about the logging system. This includes the
configuration of the various log destinations, buffered, permanent, syslog servers
(hosts) and email addresses. This also displays the latest status information for
each of these destinations.
Syntax
show log config
Mode User Exec, Privileged Exec and Global Configuration
Example To display the logging configuration use the command:
awplus# show log config
Output Figure 9-4: Example output from the show log config command
Facility: default
PKI trustpoints: example_trustpoint
Buffered log:
Status ......... enabled
Maximum size ... 100kb
Filters:
*1 Level ........ notices
Program ...... any
Facility ..... any
Message text . any
2 Level ........ informational
Program ...... auth
Facility ..... daemon
Message text . any
Statistics ..... 1327 messages received, 821 accepted by filter (2016 Oct 11
10:36:16)
Permanent log:
Status ......... enabled
Maximum size ... 60kb
Filters:
1 Level ........ error
Program ...... any
Facility ..... any
Message text . any
*2 Level ........ warnings
Program ...... dhcp
Facility ..... any
Message text . "pool exhausted"
Statistics ..... 1327 messages received, 12 accepted by filter (2016 Oct 11
10:36:16)
To Next Page
Loading...
Need help?
General
