Allied Telesis AlliedWare Plus - Ipv6 Access-List Extended (Named)

C613-50100-01 REV C Command Reference for x930 Series 1967
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
IPV
6 ACCESS-LIST EXTENDED (NAMED)
ipv6 access-list extended (named)
Overview Use this command when configuring an IPv6 extended access-list for filtering
frames that permit or deny IP, ICMP, TCP, UDP packets or ICMP packets with a
specific value based on the source or destination.
The no variant of this command removes a specified IPv6 extended access-list.
Syntax
[list-name]
ipv6 access-list extended <list-name>
no ipv6 access-list extended <list-name>
Syntax
[any|icmp|ip]
ipv6 access-list extended <list-name> {deny|permit}
{any|icmp|ip} {<ipv6-source-address/prefix-length>|any}
{<ipv6-destination-address/prefix-length>|any} [<icmp-type
<icmp-type>][log]
no ipv6 access-list extended <list-name> {deny|permit}
{any|icmp|ip} {<ipv6-source-address/prefix-length>|any}
{<ipv6-destination-address/prefix-length>|any} [<icmp-type
<icmp-type>][log]
Syntax [tcp|udp] ipv6 access-list extended <list-name> {deny|permit} {tcp|udp}
{<ipv6-source-address/prefix-length>|any} {eq <sourceport>|lt
<sourceport>|gt <sourceport>|ne
<sourceport>}{<ipv6-destination-address/prefix-length>|any}
{eq <destport>|lt <destport>|gt <destport>|ne <destport>} [log]
no ipv6 access-list extended <list-name> {deny|permit}
{tcp|udp} {<ipv6-source-address/prefix-length>|any} {eq
<sourceport>|lt <sourceport>|gt <sourceport>|ne
<sourceport>}{<ipv6-destination-addr/prefix-length>|any} {eq
<destport>|lt <destport>|gt <destport>|ne <destport>} [log]
Parameter Description
<list-name> A user-defined name for the IPv6 software extended access-
list.
Parameter Description
<list-name> A user-defined name for the IPv6 software extended
access-list.
deny The IPv6 software extended access-list rejects packets
that match the type, source, and destination filtering
specified with this command.
permit The IPv6 software extended access-list permits packets
that match the type, source, and destination filtering
specified with this command.